In the production process of electronic products, as the production and assembly of electronic components, consisting of multiple stages, so in this process, the components are likely to be contaminated with contaminated particles, resulting in electronic components quality problems, such as corrosion and rust, failure, short circuit, etc.. So many production lines will use the cleaning process for components. Sometimes, after the cleaning process in the production line, we will find some flaking on the top layer of the film capacitor as shown below. x2 amperometric capacitors,film capacitors,capacitor manufacturers.
Κατασκευαστής πυκνωτών φιλμ
This flaking phenomenon may occur when the film capacitor manufacturer is cleaned after the soldering process on the board, or is subjected to excessive mechanical stress or rinsing.
In order to prevent the degradation of component performance due to this peeling phenomenon, some suppliers such as Panasonic have made more than 50 layers of protective film on the top and bottom of film capacitors, such as ECH-U1H104J, which will not deteriorate due to such surface peeling. Even if all the protective film is peeled off, the electrical performance and reliability characteristics of these film capacitors will not be affected. x2 amperometric capacitors, film capacitors, capacitor manufacturers.
Ηλεκτρολυτικός πυκνωτής 1000uf 400v

Ηλεκτρολυτικός πυκνωτής 1000uf 400v

Ηλεκτρονικό ταχυδρομείο: sales@cucab.com